Virtual: Device Serial0 Will Start Disconnected

A: In Dynamips/GNS3, no. The hardware state is decided at boot. You must shut down, connect the cable, and restart the router. In EVE-NG with newer QEMU images, you may hot-plug, but it is not recommended.

Always read the console boot messages. That "disconnected" line is not a warning; it is a direct status report. Frequently Asked Questions (FAQ) Q: Does this happen on real Cisco hardware? A: No. Real hardware will show "%LINK-3-UPDOWN: Interface Serial0/0, changed state to down" if no cable is plugged in, but it will never announce "virtual device."

[[router R1]] image = c7200.bin serial0 = "R2 serial0" This tells Dynamips to create a direct serial cable between the two virtual devices on boot. A common mistake is logging into the router and typing: virtual device serial0 will start disconnected

The root cause? The console log from boot clearly showed: "Virtual device serial0 will start disconnected" and "Virtual device serial1 will start disconnected" . The student had never connected the cables from the router to the Frame Relay switch.

If you have ever fired up a Cisco router in Dynamips , GNS3 , EVE-NG , or Cisco Packet Tracer , you have likely seen the console output slowly crawl by until it halts at a seemingly concerning line: "Virtual device serial0 will start disconnected" For many students, this message triggers an instinct to panic. Is the router broken? Is the image corrupted? Will Serial0/0 ever come up? A: In Dynamips/GNS3, no

[[router R1]] image = c7200.bin serial0 = "disconnected" To this:

config t interface serial0 no shutdown After this, show ip interface brief still shows Serial0 down/down . In EVE-NG with newer QEMU images, you may

Now go build your topology, connect those serial cables, and watch show interface serial0 finally display the glorious words: