Ms 7826 Ver 1.0 Manual May 2026

For archival purposes, preserve a physical copy of the MS 7826 Ver 1.0 manual inside your control cabinet, as digital scans often omit the critical trimmer calibration maps and timing diagrams.

Document ID: MS-7826-V1.0-ENG Firmware Baseline: Version 1.0 Product Series: MS 7800 Industrial Control Series Introduction The MS 7826 Ver 1.0 is a specialized industrial control module, typically found in automated manufacturing environments, legacy PLC (Programmable Logic Controller) systems, or precision instrumentation racks. The "MS" designation often points to a Measurement Systems or Master Slave controller, while the 7826 model number identifies a 24-channel mixed I/O unit with isolated analog inputs. ms 7826 ver 1.0 manual

| Switch (SW1) Position | Function (Ver 1.0) | |------------------------|---------------------| | 1–4 | Binary address (ON=1, OFF=0) Example: Switch 1 ON = +1, Switch 2 ON = +2, etc. | | 5 | ON = RS-485, OFF = RS-232 | | 6 | ON = 19200 baud, OFF = 9600 baud | | 7 | ON = No parity, OFF = Even parity | | 8 | ON = 2 stop bits, OFF = 1 stop bit | Cycle power after changing DIP switches. Ver 1.0 does NOT support software-overridden DIP settings. 3.2 Modbus Register Map (Ver 1.0 Only) The manual lists the following key addresses (holding registers, function code 0x03/0x06): For archival purposes, preserve a physical copy of

[01][03][00][01][00][01][CRC_H][CRC_L] Section 4: LED Diagnostics and Error Codes (Ver 1.0 Manual, Appendix B) The MS 7826 features three LEDs on the front panel: | Switch (SW1) Position | Function (Ver 1