And always, always back up your original ECM calibration before making changes. Have you successfully unlocked your Insite using an MHH method? Share your version number and adapter type in the comments below (or on the MHH Auto forum thread #49201).
But then you see it: "Demo Mode" or "Feature Disabled."
Connect your diagnostic interface. Install the modified driver from the MHH pack (often "FTDI CDM 2.12.28 WHQL Certified").
This article is for informational and educational purposes only. The author does not condone software piracy. Always purchase a legitimate license from Cummins Inc. if you are using the software for commercial purposes.]
Open the "Keygen" or "Loader." Click "Generate" or "Install License." You should see a message: "Feature: Data Unlock – Status: Permanent."
Introduction: The Frustration of the "Demo Mode" Wall If you are a diesel mechanic, an owner-operator, or a fleet manager running Cummins engines, you have likely encountered a familiar wall of frustration. You have downloaded Cummins Insite (the industry-standard diagnostic software), you have purchased a Nexiq or inline interface, and you plug into the ECM of an ISX, QSB, or X15.
Run the Cummins Insite installer. Do NOT launch the program after installation. Select "Demo Mode" during initial setup if prompted.
