Ka 54 Remsl Top May 2026

| Specification | Value | |---------------|-------| | Component Type | Rod or Piston Seal | | Nominal Diameter (d) | 54 mm (Inner) | | Groove Width (L) | 8.1 mm to 9.5 mm (depending on housing) | | Cross Section | Asymmetric, with scraper lip | | Material | TPU + PTFE bronze-filled (TOP grade) | | Hardness (Shore A) | 92 ± 2 | | Max. Pressure | 450 bar (static), 350 bar (dynamic) | | Max. Speed | 0.5 m/s | | Temperature Range | -35°C to +110°C (intermittent +125°C) | | Fluid Compatibility | Mineral oils (HLP), synthetic esters, water-glycol |

For further technical support, consult the original component manufacturer's catalog or a certified fluid power engineer. Part numbers and specifications mentioned are based on industry standards. Always verify with your OEM documentation before ordering or installing. ka 54 remsl top

A: The TOP grade integrates an anti-extrusion element. However, for continuous pressures above 400 bar, a separate PTFE backup ring is advised. Part numbers and specifications mentioned are based on

A: Stored in cool, dark, and dry conditions (<35°C, no ozone), it lasts 10 years. However, for continuous pressures above 400 bar, a

A: The "-2" suffix usually indicates a wider groove version (e.g., 10.5 mm instead of 8.1 mm) for heavier-duty applications. Conclusion The KA 54 REMSL TOP is far more than a rubber ring; it is a precision-engineered component that ensures the reliability of hydraulic systems across multiple industries. Understanding its specifications, correct installation, and common pitfalls can save thousands in downtime and repairs.

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | External leakage at rest | Incorrect groove depth or seal compression | Remachine housing; replace seal | | Chunking or tearing | High pressure spikes beyond 500 bar | Install backup ring; reduce system pressure | | Hardening/cracking | Fluid temperature exceeding 125°C | Add cooler; switch to FKM version | | Spiral twisting | Uneven rod extension speed (pulsation) | Optimize pump flow; check rod straightness | | Abrasion marks | Contaminated fluid (ISO 21/18 or worse) | Change filters; flush system |