Emax Es08ma Ii Datasheet Now
#include <Servo.h> Servo myServo; const int servoPin = 9; // PWM-capable pin
| Model | Torque @6V | Speed @6V | Weight | Bearings | Price Range | |-------|------------|-----------|--------|----------|--------------| | | 2.0 kg·cm | 0.10 sec | 12.5g | Dual | $ | | TowerPro MG90S | 2.2 kg·cm | 0.11 sec | 13.4g | Single | $ | | Hitec HS-65MG | 1.9 kg·cm | 0.12 sec | 11.2g | Dual | $$$ | | Savöx SH-0255MG | 2.5 kg·cm | 0.09 sec | 12.9g | Dual | $$$$ |
void setup() myServo.attach(servoPin, 1000, 2000); // min, max pulse width myServo.write(90); // center position delay(1000); Emax Es08ma Ii Datasheet
Introduction: Why the Emax ES08MA II Stands Out In the world of micro servos, few models have achieved the legendary status of the Emax ES08A series. The Emax ES08MA II is the latest iteration of this popular actuator, bridging the gap between budget-friendly plastic gear servos and expensive industrial-grade models. For anyone searching for the "Emax ES08MA II Datasheet," you likely need precise technical specifications, wiring diagrams, torque curves, and application notes.
| Wire Color | Signal | Function | |------------|--------|----------| | | GND | Ground (0V) – connect to power supply negative | | Red | VCC | Positive power – 4.8V to 6.0V DC | | Orange | PWM | Control signal – 3.3V/5V logic level (50Hz) | #include <Servo
for (int angle = 180; angle >= 0; angle--) myServo.write(angle); delay(15);
| Parameter | Value | |-----------|-------| | | Emax ES08MA II | | Type | Micro Analog Servo | | Gear Material | Metal (Brass & Aluminum combination) | | Weight | 12.5g ± 0.2g | | Dimensions | 23 x 12.2 x 24 mm (0.91 x 0.48 x 0.94 in) | | Operating Voltage | 4.8V to 6.0V (6.0V recommended for max torque) | | Stall Torque (4.8V) | 1.6 kg·cm (22.2 oz·in) | | Stall Torque (6.0V) | 2.0 kg·cm (27.7 oz·in) | | Operating Speed (4.8V) | 0.12 sec/60° | | Operating Speed (6.0V) | 0.10 sec/60° | | Dead Band Width | ≤5 μs | | Temperature Range | -20°C to +60°C | | Connector Type | JR (Futaba compatible – 3-pin 0.1” spacing) | | Wire Length | 250 mm ±10 mm | | Wire Color | Signal | Function |
void loop() // Sweep from 0 to 180 degrees for (int angle = 0; angle <= 180; angle++) myServo.write(angle); delay(15); // Wait for servo to reach position (speed: 0.10 sec/60° = ~10ms per 10°)