Anytone At5555n Ii Service Menu Work -

If you own an Anytone AT-5555N II , you already know it is a powerhouse in the world of 10-meter and 12-meter amateur radio, as well as a favorite among freebanders. This radio is celebrated for its robust build, excellent receiver sensitivity, and the famous "N2" firmware improvements over its predecessor.

However, if you are a ham with a bench, the service menu turns the AT-5555N II from a "good off-the-shelf radio" into a . Conclusion The anytone at5555n ii service menu work is not a magic factory reset—it is a sophisticated calibration toolkit. By understanding parameters like rEF , PA-H , and Pc-H , you can restore drifting radios, optimize modulation for contesting, and ensure your signal is clean and on-frequency. anytone at5555n ii service menu work

| Parameter | Function | Typical Range | When to Adjust | | :--- | :--- | :--- | :--- | | | Reference Frequency (PLL Master Clock) | 0 to 255 | Most common fix. Adjusts the master oscillator. | | PA-H | High Power AM/FM Bias | 0-255 | Sets final transistor bias for high power. | | PA-L | Low Power AM/FM Bias | 0-255 | Sets final transistor bias for low power. | | Pc-H | SSB High Power ALC Threshold | 0-255 | Limits peak envelope power on SSB. | | Pc-L | SSB Low Power ALC Threshold | 0-255 | Limits low power SSB. | | Mod | AM Modulation Depth Limit | 0-255 | Maximum AM percentage (Factory ~95%). | | S-1 through S-9 | S-Meter Calibration | Varies | Adjusts receive signal strength reading. | The Most Important Parameter: rEF (Frequency Calibration) The most common reason for entering the service menu is drifting off frequency. A fellow ham says, "You are 60 Hz low on 27.555 MHz." If you own an Anytone AT-5555N II ,

Achieve 40W carrier with 90-95% positive peak modulation. Conclusion The anytone at5555n ii service menu work

Entering the service menu and changing values without proper equipment (frequency counter, oscilloscope, RF power meter, and dummy load) can permanently detune your radio, making it unusable. Proceed with caution.

Wattmeter with PEP function (e.g., Bird 43 or Diawa) + Dummy Load + Oscilloscope (ideal).

If you don't own a frequency counter or a Bird wattmeter, do not open the service menu. Instead, send the radio to a reputable tech. The cost of calibration ($50-$80) is far less than the cost of a new AT-5555N II ($300+).